Before you start
- PAN-OS 10.x or later, admin access
- Separate zone/VLAN for guest traffic
- Firewall access to HotSpot servers on 1812/1813 UDP and 514/6514 syslog
1. RADIUS server profile
-
Device›Server Profiles›RADIUS›Add
- Name: HotSpot
- Server: <HotSpot RADIUS IP>
- Port: 1812
- Secret: <Shared secret>
- Timeout: 5 · Retries: 3
-
Device›Authentication Profile›Add
- Name: HotSpot-Auth
- Type: RADIUS
- Server Profile: HotSpot
2. Guest zone and policy
-
Network›Zones›Add
- Name: Guest · Type: Layer3
- Assign the guest interface/VLAN to this zone
-
Policies›Security›Add
- Source Zone: Guest → Destination Zone: Internet
- Application: web-browsing, ssl
- Action: Allow · Log at Session End: enabled
Session-end logs are required for 5651 matching.
3. User-ID mapping
-
Device›User Identification›User Mapping
- Add the HotSpot source for RADIUS accounting listening
HotSpot can also send user-to-IP mapping over syslog at portal login; the setup team will guide you.
4. Syslog to LogIQ
-
Device›Server Profiles›Syslog›Add
- Name: LogIQ
- Server: <LogIQ collector IP>
- Transport: UDP · Port: 514
- Format: BSD · Facility: LOG_USER
-
Device›Log Settings›System / Traffic
- Syslog profile: LogIQ
- Use a Log Forwarding profile on every rule for traffic logs
Verification
- Guest sessions should appear with usernames in Monitor > Logs > Traffic.
- The Palo Alto source should show as active in the LogIQ live stream.
Menu names may differ slightly between firmware versions. If you get stuck, our installation team supports you remotely.